H3C S7500E Series

Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-16
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark ip-precedence 6
2.2.12 remark local-precedence
Syntax
remark local-precedence local-precedence
undo remark local-precedence
View
Traffic behavior view
Parameters
local-precedence: Local precedence to be set for packets, in the range of 0 to 7.
Description
Use the remark local-precedence command to configure the action of setting local
precedence for a traffic behavior.
Use the undo remark local-precedence command to remove the action of remarking
local precedence.
Note that, when the remark dot1p command is used together with the remark
local-precedence command, the 802.1p precedence to be set for packets must be the
same as the local precedence to be set for packets. Otherwise, the corresponding
policy cannot be applied successfully.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action to set local precedence to 2 for a traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark local-precedence 2
2.2.13 remark service-vlan-id
Syntax
remark service-vlan-id vlan-id-value
undo remark service-vlan-id
View
Traffic behavior view