Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-30
z Configuration of the undo terminal monitor command automatically disables the
monitoring of log, trap, and debugging information.
By default, the monitoring of the console is enabled and the monitoring of the terminal is
disabled.
Examples
# Enable the monitoring of system information on the current terminal.
<Sysname> terminal monitor
% Current terminal monitor is on
1.1.31 terminal trapping
Syntax
terminal trapping
undo terminal trapping
View
User view
Parameters
None
Description
Use the terminal trapping command to enable the display of trap information on the
current terminal.
Use the undo terminal trapping command to disable the display of trap information on
the current terminal.
By default, the display of trap information on the current terminal is enabled.
Note that the trap information is displayed (using the terminal trapping command)
only after the monitoring of system information is enabled on the current terminal first
(using the terminal monitor command).
Examples
# Enable the display of trap information on the current terminal.
<Sysname> terminal trapping
% Current terminal trapping is on
To Next Page
Loading...
Need help?
General
