Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-3
Parameters
interface-type interface-number: Specifies an interface by its type and number. This
configuration can take effect only if PIM-SM is enabled on the interface.
hash-length: Hash mask length for RP selection calculation, in the range of 0 to 32. If
you do not include this keyword in your command, the corresponding global setting will
be used.
priority: Priority of the C-BSR, in the range of 0 to 255. If you do not include this keyword
in your command, the corresponding global setting will be used. A larger value of this
argument means a higher priority.
Description
Use the c-bsr command to configure the specified interface as a C-BSR.
Use the undo c-bsr command to remove the related C-BSR configuration.
No C-BSR is configured by default.
Related commands: pim sm, c-bsr hash-length, c-bsr priority, c-rp.
Examples
# Configure VLAN-interface 100 to be a C-BSR.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-bsr vlan-interface 100
4.1.4 c-bsr admin-scope
Syntax
c-bsr admin-scope
undo c-bsr admin-scope
View
PIM view
Parameters
None
Description
Use the c-bsr admin-scope command to enable BSR administrative scoping to
implement RP-Set distribution based on BSR admin-scope regions.
Use the undo c-bsr admin-scope command to disable BSR administrative scoping.
To Next Page
Loading...
Need help?
General
