H3C S7500E Series

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-6
1.1.5 display link-aggregation verbose
Syntax
display link-aggregation verbose [ agg-id ]
View
Any view
Parameters
agg-id: ID of an existing link aggregation group.
Description
Use the display link-aggregation verbose command to display detailed information
about the specified or all link aggregation groups.
You may find that information about the remote system for a manual link aggregation
group is either replaced by none or not displayed at all. This is normal because this type
of aggregation group has no knowledge of its partner.
Examples
# Display detailed information about all the link aggregation groups.
<Sysname> display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Flags: A -- LACP_Activity, B -- LACP_timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregation ID: 1, AggregationType: Manual, Loadsharing Type: Shar
Aggregation Description:
System ID: 0x8000, 0000-fc00-6504
Port Status: S -- Selected, U -- Unselected
Local:
Port Status Priority Oper-Key Flag
-------------------------------------------------------------------------
Eth2/0/23 S 32768 1 {}
Remote:
Actor Partner Priority Oper-Key SystemID Flag
-------------------------------------------------------------------------
Eth2/0/23 0 0 0 0x0000,0000-0000-0000 {}