H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-13
Examples
# Advertise only the default route via VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng default-route only
# Advertise the default route together with other routes via VLAN-interface 101.
<Sysname> system-view
[Sysname] interface vlan-interface 101
[Sysname-Vlan-interface101] ripng default-route originate
2.1.14 ripng enable
Syntax
ripng process-id enable
undo ripng enable
View
Interface view
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use the ripng enable command to enable RIPng on the specified interface.
Use the undo ripng enable command to disable RIPng on the specified interface.
By default, RIPng is disabled on an interface.
Examples
# Enable RIPng100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng 100 enable
2.1.15 ripng metricin
Syntax
ripng metricin value
undo ripng metricin

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English