Command Manual – ACL
H3C S7500E Series Ethernet Switches Chapter 1 ACL Configuration Commands
1-26
Description
Use the description command to create an IPv6 ACL description, to describe the
purpose of the ACL for example.
Use the undo description command to remove the IPv6 ACL description.
By default, no IPv6 ACL description is present.
Examples
# Create a description for IPv6 ACL 2000.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] description This acl is used in eth 0
# Create a description for IPv6 ACL 3000.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] description This acl is used in eth 0
1.3.5 display acl ipv6
Syntax
display acl ipv6 { acl6-number | all | name acl6-name }
View
Any view
Parameters
acl6-number: IPv6 ACL number, which must be in the following ranges:
z 2000 to 2999 for basic IPv6 ACLs
z 3000 to 3999 for advanced IPv6 ACLs
all: All IPv6 ACLs.
name acl6-name: Specifies the name of the ACL, which is a case insensitive string of 1
to 32 characters. It must start with an English letter and cannot be the English word of
all to avoid confusion.
Description
Use the display acl ipv6 command to display information about specified or all IPv6
ACLs.
The output will be displayed in matching order.
Examples
# Display information about IPv6 ACL 2001.
To Next Page
Loading...
Need help?
General
