Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-51
1.2.18 secondary accounting
Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS scheme view
Parameters
ip-address: IP address of the secondary accounting server, in dotted decimal notation.
The default is 0.0.0.0.
port-number: UDP port number of the secondary accounting server, which ranges from
1 to 65535 and defaults to 1813.
Description
Use the secondary accounting command to configure the IP address and UDP port of
the secondary RADIUS accounting server.
Use the undo secondary accounting command to restore the defaults.
Note that:
z The IP addresses of the primary and secondary accounting servers cannot be the
same. Otherwise, the configuration fails.
z The RADIUS service port configured on the device and that of the RADIUS server
must be consistent.
Related commands: key, radius scheme, state.
Examples
# Set the IP address of the secondary accounting server for RADIUS scheme radius1
to 10.110.1.1 and the UDP port of the server to 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary accounting 10.110.1.1 1813
1.2.19 secondary authentication
Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
To Next Page
Loading...
Need help?
General
