H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-20
Field Description
Keepalive timeout, so connections
disconnected
Number of connections dropped
because of keepalive response timeout
Initiated connections Number of initiated connections
accepted connections Number of accepted connections
established connections Number of established connections
Closed connections Number of closed connections
dropped
Number of dropped connections (after
SYN is received from the peer)
initiated dropped
Number of initiated but dropped
connections (before SYN is received
from the peer)
1.1.12 display tcp ipv6 status
Syntax
display tcp ipv6 status
View
Any view
Parameters
None
Description
Use the display tcp ipv6 command to display the IPv6 TCP connection status.
Examples
# Display the IPv6 TCP connection status.
<Sysname> display tcp ipv6 status
TCP6CB Local Address Foreign Address State
045d8074 ::->21 ::->0 Listening
Table 1-12 Description on fields of the display tcp ipv6 status command
Field Description
TCP6CB IPv6 address of the TCP control block (hexadecimal)
Local Address Local IPv6 address and port number
Foreign Address Remote IPv6 address and port number

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English