To Next Page

To Previous Page

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands

4-14

Description

Use the display isis mesh-group command to display IS-IS mesh-group.

Examples

# Configure VLAN-interface 10 and VLAN-interface 20 on a switch to belong to

mesh-group 100. (The process to establish VLAN-interface 10 and VLAN-interface 20

is omitted.)

<Sysname> system-view

[Sysname] interface vlan-interface 10

[Sysname-Vlan-interface10] isis mesh-group 100

[Sysname-Vlan-interface10] quit

[Sysname] interface vlan-interface 20

[Sysname-Vlan-interface20] isis mesh-group 100

# Display the configuration information of IS-IS mesh-group.

[Sysname-Vlan-interface20] display isis mesh-group

Mesh Group information for ISIS(1)

----------------------------------

Interface Status

Vlan10 100

Vlan20 100

Table 4-5 Description on the fields of the display isis mesh-group command

Field Description

Interface Interface name

Status Mesh-group number of the interface

4.1.12 display isis name-table

Syntax

display isis name-table [ process-id ]

View

Any view

Parameters

process-id: IS-IS process ID, in the range of 1 to 65535.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series