To Next Page

To Previous Page

Command Manual – IPv6 Configuration

H3C S7500E Series Ethernet Switches Chapter 3 Tunneling Configuration Commands

3-3

<Sysname2> system-view

[Sysname2] interface Tunnel 1/0/3

[Sysname2-Tunnel1/0/3] source 192.100.1.1

[Sysname2-Tunnel1/0/3] destination 193.101.1.1

3.1.3 display interface tunnel

Syntax

display interface tunnel [ number ]

View

Any view

Parameters

number: Tunnel interface number. If the number argument is not specified, the

information of all tunnel interfaces will be displayed.

Description

Use the display interface tunnel command to display related information of a

specified tunnel interface, such as source address, destination address, and

encapsulation mode.

Related commands: interface tunnel, source, destination, tunnel-protocol.

Examples

# Display the information of the interface Tunnel 1/0/3.

<Sysname> display interface Tunnel1/0/3

Tunnel1/0/3 current state: UP

Line protocol current state: UP

Description: Tunnel1/0/3 Interface

The Maximum Transmit Unit is 64000

Internet Address is 10.1.2.1/24 Primary

Encapsulation is TUNNEL, aggregation ID not set

Tunnel source 192.13.2.1, destination 192.13.2.2

Tunnel protocol/transport IPv6/IP

Last 300 seconds input: 0 bytes/sec, 0 packets/sec

Last 300 seconds output: 0 bytes/sec, 0 packets/sec

361 packets input, 9953388 bytes

0 input error

361 packets output, 30324 bytes

0 output error

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series