H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 3 IGMP Configuration Commands
3-16
If the specified multicast address is in the SSM multicast address range, and if a
multicast source address is specified in the command, multicasts carrying the (S, G)
entry, namely the source address information, can be sent out through this interface.
 Note:
z The igmp static-group command cannot be used in VLAN interface view. To
configure a specific Layer 2 port or ports to join a multicast group as static
member(s), use the igmp-snooping static-group command.
z The igmp-snooping static-group command is effective for both IGMP
Snooping–enabled VLANs and VLANs with IGMP enabled on the corresponding
VLAN interfaces.
Related commands: igmp-snooping static-group in
IGMP Snooping Configuration
Commands
.
Examples
# Configure LoopBack 1 to be a statically connected member of multicast group
224.1.1.1.
<Sysname> system-view
[Sysname] interface LoopBack 1
[Sysname-LoopBack1] igmp static-group 224.1.1.1
# Configure LoopBack 2 so that it can forward multicasts that multicast source
192.168.1.1 sends to multicast group 232.1.1.1.
<Sysname> system-view
[Sysname] interface LoopBack 2
[Sysname-LoopBack2] igmp static-group 232.1.1.1 source 192.168.1.1
3.1.16 igmp timer other-querier-present
Syntax
igmp timer other-querier-present interval
undo igmp timer other-querier-present
View
Interface view
Parameters
interval: IGMP other querier present interval in seconds, in the range of 60 to 300.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English