Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 2 FTP Configuration Commands
2-13
of the transmitted packets. If no primary IP address is configured on the source
interface, the connection fails.
ip source-ip-address: The source IP address of the current FTP client. This source
address must be the one that has been configured on the device.
Description
Use the ftp command to log onto the remote FTP server and enter FTP client view.
Note that:
z This command applies to IPv4 network.
z If you use this command without specifying any parameters, you will simply enter
the FTP client view without logging onto the FTP server.
z If you specify the parameter, you will be asked to enter the username and
password for accessing the FTP server.
z The priority of the source address specified with this command is higher than that
with the ftp client source command. If you specify the source address with the ftp
client source command first and then with the ftp command, the source address
specified with the ftp command is used to communicate with the FTP server.
Related commands: ftp client source.
Examples
# Log from the current device Sysname1 onto the device Sysname2 with the IP
address of 192.168.0.211. The source IP address of the packets sent is 192.168.0.212.
<Sysname1> ftp 192.168.0.211 source ip 192.168.0.212
Trying 192.168.0.211 ...
Press CTRL+K to abort
Connected to 192.168.0.211.
220 FTP Server ready
User(192.168.0.211:(none)):abc
331 Password required for abc
Password:
230 Login OK
[ftp]
2.2.13 ftp client source
Syntax
ftp client source { interface interface-type interface-number | ip source-ip-address }
undo ftp client source
View
System view
To Next Page
Loading...
Need help?
General
