H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-15
Examples
# Set the maximum number of routing entries in the multicast forwarding table to 200.
<Sysname> system-view
[Sysname] multicast forwarding-table route-limit 200
6.1.11 multicast load-splitting
Syntax
multicast load-splitting { source | source-group }
undo multicast load-splitting
View
System view
Parameters
source: Specifies to implement per-source load splitting.
source-group: Specifies to implement per-source and per-group load splitting
simultaneously.
Description
Use the multicast load-splitting command to enable load splitting of multicast traffic.
Use the undo multicast load-splitting command to disable load splitting of multicast
traffic.
By default, load splitting of multicast traffic is disabled.
Examples
# Enable per-source load splitting of multicast traffic.
<Sysname> system-view
[Sysname] multicast load-splitting source
6.1.12 multicast longest-match
Syntax
multicast longest-match
undo multicast longest-match
View
System view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English