H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-19
Field Description
Address family IPv4 Unicast
Routes are advertised and received in the form
of IPv4 unicast
Received Total numbers of received packets and updates
Sent Total numbers of sent packets and updates
Maximum allowed prefix number Maximum allowed prefix number
Threshold Threshold value
Minimum time between
advertisement runs
Minimum time between route advertisements
Optional capabilities Optional capabilities enabled by the peer
Peer Preferred Value
Preferred value specified for the routes from the
peer
Routing policy configured Local routing policy
5.1.20 display bgp routing-table
Syntax
display bgp routing-table [ ip-address [ { mask | mask-length } [ longer-prefixes ] ] ]
View
Any view
Parameters
ip-address: Destination IP address.
mask: Network mask, in dotted decimal notation.
mask-length: Mask length, in the range 0 to 32.
longer-prefixes: Matches the longest prefix.
Description
Use the display bgp routing-table command to display specified BGP routing
information in the BGP routing table.
Examples
# Display BGP routing table information.
<Sysname> display bgp routing-table
Total Number of Routes: 1

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English