H3C S7500E Series Command Manual

Command Manual – NTP
H3C S7500E Series Ethernet Switches Chapter 1 NTP Configuration Commands
1-8
By default, no NTP authentication key is set.
Caution:
z Presently the system supports only the MD5 algorithm for key authentication.
z You can set a maximum of 1,024 keys for each device.
z If an NTP authentication key is specified as a trusted key, the key automatically
changes to not trusted after you delete the key. In this case, you do not need to
execute the undo ntp-service reliable authentication-keyid command.
Examples
# Set an MD5 authentication key, with the key ID of 10 and key value of BetterKey.
<Sysname> system-view
[Sysname] ntp-service authentication-keyid 10 authentication-mode md5
BetterKey
1.1.7 ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
VLAN interface view
Parameters
None
Description
Use the ntp-service broadcast-client command to configure the device to work in the
NTP broadcast client mode.
Use the undo ntp-service broadcast-client command to remove the device as an
NTP broadcast client.
Examples
# Configure the device to work in the broadcast client mode and receive NTP broadcast
messages on VLAN-interface 1.
<Sysname> system-view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English