Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-24
aggregation agg-id: Number of the specified port aggregation group. The specified
port aggregation group must already exist. You can use the display link-aggregation
summary command to display brief information of all existing port aggregation groups.
Description
Use the port-group manual command to create a manual port group and enter
manual port group view.
Use the port-group aggregation command to enter aggregation group view.
Use the undo port-group manual command to remove a manual port group.
By default, no manual port group is created.
Examples
# Create a manual port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]
1.1.23 reset counters interface
Syntax
reset counters interface [ interface-type [ interface-number ] ]
View
User view
Parameters
interface-type: Port type.
interface-number: Port number.
Description
Use the reset counters interface command to reset statistics for a specified port.
To sample network traffic within a period of time for a port, you need to reset the original
port statistics.
z If neither port type nor port number is specified, all port information will be reset;
z If only port type is specified, then only information of this particular type of ports will
be reset.
z If both port type and port number are specified, then only information of the
specified port will be reset.
To Next Page
Loading...
Need help?
General
