H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-55
By default, hello messages are sent at the interval of 30 seconds.
Related commands: pim timer hello.
Examples
# Set the global hello interval to 40 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer hello 40
4.1.64 timer join-prune
Syntax
timer join-prune interval
undo timer join-prune
View
PIM view
Parameters
interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the timer join-prune command to configure the join/prune interval globally.
Use the undo timer join-prune command to restore the system default.
By default, the join/prune interval is 60 seconds.
Related commands: pim timer join-prune.
Examples
# Set the global join/prune interval to 80 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer join-prune 80