Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-19
Table 3-6 Description on the fields of the display ospf interface command
Field Description
Area Area ID of the interface
IP address Interface IP address (regardless of whether TE is enabled or not)
Type Interface network type: PTP, PTMP, Broadcast, or NBMA
State
Interface state defined by interface state machine: DOWN,
Waiting, p-2-p, DR, BDR, or DROther
Cost Interface cost
Pri Router priority
DR The DR on the interface’s network segment
BDR The BDR on the interface’s network segment
3.1.16 display ospf lsdb
Syntax
display ospf [ process-id ] lsdb [ brief | [ { ase | router | network | summary | asbr |
nssa | opaque-link | opaque-area | opaque-as } [ link-state-id ] ] [ originate-router
advertising-router-id | self-originate ] ]
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
brief: Displays brief LSDB information.
ase: Displays Type-5 LSA (AS External LSA) information in the LSDB.
router: Displays Type-1 LSA (Router LSA) information in the LSDB.
network: Displays Type-2 LSA (Network LSA) information in the LSDB.
summary: Displays Type-3 LSA (Network Summary LSA) information in the LSDB.
asbr: Displays Type-4 LSA (ASBR Summary LSA) information in the LSDB.
nssa: Displays Type-7 LSA (NSSA External LSA) information in the LSDB.
opaque-link: Displays Type-9 LSA (Opaque-link LSA) information in the LSDB.
opaque-area: Displays Type-10 LSA (Opaque-area LSA) information in the LSDB.
opaque-as: Displays Type-11 LSA (Opaque-AS LSA) information in the LSDB.
link-state-id: Link state ID, in the IP address format.