Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-1
Chapter 1 Commands for Logging into an Ethernet
Switch
1.1 Commands for Logging into an Ethernet Switch
1.1.1 activation-key
Syntax
activation-key character
undo activation-key
View
AUX interface view
Parameters
character: Shortcut key for starting terminal sessions, a character or its ASCII decimal
equivalent in the range 0 to 127; or a string of 1 to 3 characters.
Description
Use the activation-key command to define a shortcut key for starting a terminal
session.
Use the undo activation-key command to restore the default shortcut key.
You can use a single character (or its corresponding ASCII code value in the range 0 to
127) or a string of 1 to 3 characters to define a shortcut key. In the latter case, the
system takes only the first character to define the shortcut key. For example, if you input
an ASCII code value 97, the system wi
ll set the shortcut key to <a>; if you input the
string b@c, the system will set the shortcut key to <b>.
You may use the display current-configuration command to verify the shortcut key
you have defined.
By default, pressing Enter key will start a terminal session.
Examples
# Set the shortcut key for starting terminal sessions to <s>.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] activation-key s
To Next Page
Loading...
Need help?
General
