H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-3
Description
Use the default-route originate cost command to advertise a default route with the
specified metric to RIP neighbors.
Use the undo default-route originate command to disable the sending of a default
route.
By default, no default route is sent to RIP neighbors.
The RIP router with this feature configured will not receive any default routes from RIP
neighbors.
Examples
# Send a default route with a metric of 2 to RIP neighbors.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default-route originate cost 2
# Disable default route sending.
[Sysname-rip-100] undo default-route originate
2.1.4 display rip
Syntax
display rip [ process-id ]
View
Any view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the display rip command to display the current status and configuration
information of the specified RIP process.
If process-id is not specified, information about all configured RIP processes is
displayed.
Examples
# Display the current status and configuration information of all configured RIP
processes.
<Sysname> display rip
Public VPN-instance name :