H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-7
Using the apply isis level-1 command in routing policy view will generate a default
route in L1 LSP. Using the apply isis level-2 command in routing policy view will
generate a default route in L2 LSP. Using the apply isis level-1-2 command in routing
policy view will generate a default route in L1 LSP and L2 LSP respectively.
Examples
# Generate a default route in L2 LSP.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] default-route-advertise
4.1.7 display isis brief
Syntax
display isis brief [ process-id ]
View
Any view
Parameters
process-id: IS-IS process ID, in the range of 1 to 65535.
Description
Use the display isis brief command to view brief IS-IS configuration information.
Examples
# Display brief IS-IS configuration information.
<Sysname> display isis brief
ISIS (1) Protocol Brief Information :
network-entity:
10.0000.0000.0001.00
is-level :level-1-2
cost-style: narrow
preference : 15
Lsp-length receive : 1497
Lsp-length originate : level-1 1497
level-2 1497
Timers:
spf-slice-size: 0