H3C S7500E Series

Command Manual – QinQ-BPDU Tunneling
H3C S7500E Series Ethernet Switches Chapter 1 QinQ Configuration Commands
1-2
1.1.2 if-match customer-vlan-id
Syntax
if-match customer-vlan-id vlan-id-list
undo if-match customer-vlan-id vlan-id-list
View
Class view
Parameters
vlan-id-list: Customer VLAN IDs. You can specify up to eight VLAN IDs for the
argument in the form of vlan-id to vlan-id or multiple discontinuous space-separated
VLAN IDs. A VLAN ID ranges from 1 to 4094.
Description
Use the if-match customer-vlan-id command to use the specified customer VLAN
ID(s) as the match criterion.
Use the undo if-match customer-vlan-id command to remove the match criterion.
Example
# Create class class1 and classify frames of customer VLAN 9 through 100 to class 1.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match customer-vlan-id 9 to 100
1.1.3 nest top-most vlan-id
Syntax
nest top-most vlan-id vlan-id
undo nest
View
Traffic behavior view
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094.
Description
Use the nest top-most vlan-id command to configure the action of creating an outer
VLAN tag for the traffic behavior.
Use the undo nest command to remove the action.