H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-33
View
Interface view
Parameters
symbolic-name: Specifies a name for the local LAN, a string of 1 to 64 characters.
Description
Use the isis dis-name command to configure a name for local LAN. If the local router is
the DIS, the name will be advertised in a pseudonode LSP packet.
Use the undo isis dis-name command to disable this function.
No name is configured by default.
Note that this command takes effect only on a router with the dynamic hostname
process enabled. This command is not supported on a Point-to-Point interface.
 Note:
This command is not available in the loopback interface view.
Examples
# Configure the name as LOCALAREA for the local LAN.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis dis-name LOCALAREA
4.1.29 isis dis-priority
Syntax
isis dis-priority value [ level-1 | level-2 ]
undo isis dis-priority [ level-1 | level-2 ]
View
Interface view
Parameters
value: Specifies a priority for DIS selection, ranging from 0 to 127.
level-1: Applies the DIS selection priority to Level-1.
level-2: Applies the DIS selection priority to level-2.