H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-23
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, apply ip-address next-hop, apply
local-preference, apply cost, apply origin, apply tag.
Examples
# Create routing policy 1 with node 10 and matching mode as permit, and then enter
routing policy view.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy]
6.2 IPv4 Routing Policy Configuration Commands
6.2.1 apply ip-address next-hop
Syntax
apply ip-address next-hop ip-address
undo apply ip-address next-hop
View
Routing policy view
Parameters
ip-address: IP address of the next hop.
Description
Use the apply ip-address next-hop command to set a next hop for IPv4 routing
information.
Use the undo apply ip-address next-hop command to remove the clause
configuration.
No next hop address is set for IPv4 routing information by default.
It is invalid to use the apply ip-address next-hop command to set a next hop when
redistributing routes.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply local-preference, apply
cost, apply origin, apply tag.
Examples
# Create routing policy policy1 with node 10, matching mode permit. If passing AS
path ACL 1, a route‘s next hop is set to 193.1.1.8.
<Sysname> system-view