H3C S7500E Series Command Manual

Command Manual – MSTP
H3C S7500E Series Ethernet Switches Chapter 1 MSTP Configuration Commands
1-33
<Sysname> system-view
[Sysname] stp instance 0 root secondary bridge-diameter 5 hello-time 300
1.1.34 stp root-protection
Syntax
stp root-protection
undo stp root-protection
View
Ethernet interface view, port group view
Parameters
None
Description
Use the stp root-protection command to enable the root guard function on the port(s).
Use the undo stp root-protection command to disable the root guard function on the
port(s).
By default, the root guard function is disabled.
Configured in Ethernet interface view, the setting is effective on the current port only;
configured in port group view, the setting is effective on all ports in the port group.
Examples
# Enable the root guard function for port GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] stp root-protection
1.1.35 stp tc-protection
Syntax
stp tc-protection enable
stp tc-protection disable
View
System view
Parameters
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English