Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-5
The IPv6 prefix range is determined by prefix-length and [ min-prefix-length,
max-prefix-length ]. If both mask-length and [ min-mask-length, max-mask-length ] are
specified, then the IPv6 addresses must satisfy both of them.
If ipv6-address prefix-length is specified as :: 0, then only the default route matches.
If you want it to match all the routes, configure it as :: 0 less-equal 128.
Examples
# Permit the IPv6 addresses with mask length between 32 bits and 64 bits.
<Sysname> system-view
[Sysname] ip ipv6-prefix abc permit :: 0 greater-equal 32 less-equal 64
# Deny the IPv6 addresses with prefix as 3FFE:D00::/32, prefix length greater than or
equal to 32 bits.
<Sysname> system-view
[Sysname] ip ipv6-prefix abc deny 3FEE:D00:: 32 less-equal 128
6.2.5 reset ip ipv6-prefix
Syntax
reset ip ipv6-prefix [ ipv6-prefix-name ]
View
User view
Parameters
ipv6-prefix-name: IPv6 prefix list name, a string of 1 to 19 characters.
Description
Use the reset ip ipv6-prefix command to clear the statistics of the specified IPv6 prefix
list. If no name is specified, the statistics of all IPv6 prefix lists will be cleared.
Examples
# Clear the statistics of IPv6 prefix list abc.
<Sysname> reset ip ipv6-prefix abc
To Next Page
Loading...
Need help?
General
