Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GARP/GVRP Configuration Commands
4-4
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] garp timer join 25
4.1.4 garp timer leaveall
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Parameters
timer-value: Leaveall timer setting, in the range 65 to 32765 (in centiseconds), Note
that the setting of the leaveall timer must be a multiple of 5 centiseconds and must be
greater than the leave timer settings of all the ports.
Description
Use the garp timer leaveall command to set the leaveall timer of GARP.
Use the undo garp timer leaveall command to restore the default. This may fail if the
default is less than the setting of the current leave timer.
By default, the setting of the leaveall timer is 1000 centiseconds (that is, 10 seconds).
A leaveall timer starts upon the start of a GARP application entity. When this timer
expires, the entity sends a LeaveAll message so that other entities can re-register its
attribute information and starts another leaveall timer at the same time.
Each time a device on the network receives a LeaveAll message, it resets its leaveall
timer. Therefore, a GARP application entity may send LeaveAll messages at the
interval set by its leaveall timer or the leaveall timer on another device on the network,
whichever is smaller.
Related commands: display garp timer.
Examples
# Set the leaveall timer to 100 centiseconds, assuming that the leave timer is 60
centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 100
To Next Page
Loading...
Need help?
General
