Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-5
current-configuration command after this command is configured successfully;
otherwise, this command may not be executed correctly.
Examples
# Execute the batch file test.bat in the root directory.
<Sysname> system-view
[Sysname] execute test.bat
1.1.6 file prompt
Syntax
file prompt { alert | quiet }
View
System view
Parameters
alert: Enables the system to warn you about operations that may bring undesirable
results such as file corruption or data loss.
quiet: Disables the system to warn you about any operation.
Description
Use the file prompt command to set a prompt mode for file operations.
By default, the prompt mode is alert.
Note that when the prompt mode is set to quiet, the system does not warn for any file
operation. To prevent undesirable consequents resulted from misoperations, the alert
mode is preferred.
Examples
# Set the file operation prompt mode to alert.
<Sysname> system-view
[Sysname] file prompt alert
1.1.7 fixdisk
Syntax
fixdisk device
View
User view
To Next Page
Loading...
Need help?
General
