Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-4
This command supports the wildcard *.
Examples
# Display information about all files and folders.
<Sysname> dir /all
Directory of flash:/
0 -rw- 6985954 Apr 26 2005 21:06:29 mainup.bin
1 -rwh 1842 Apr 27 2005 04:37:17 private-data.txt
2 -rw- 1518 Apr 26 2005 12:05:38 config.cfg
3 -rw- 2045 May 04 2005 15:50:01 backcfg.cfg
4 -rwh 428 Apr 27 2005 16:41:21 hostkey
5 -rwh 572 Apr 27 2005 16:41:31 serverkey
6 -rw- 2737556 Oct 12 2005 01:31:44 [a.app]
64389 KB total (16166 KB free)
[ ] indicates this file is in the recycle bin.
1.1.5 execute
Syntax
execute filename
View
System view
Parameters
filename: Name of a batch file with a .bat extension.
Description
Use the execute command to execute the specified batch file.
Batch files are command line files. Executing a batch file is to execute a set of
command lines in the file.
You should not include invisible characters in a batch file. If an invisible character is
found during the execution, the batch process will abort and the commands that have
been executed cannot be cancelled.
Not every command in a batch file is sure to be executed. For example, if a certain
command is not correctly configured, the system omits this command and goes to the
next one.
A batch file does not support hot backup.
Each configuration command in a batch file must be a standard configuration command,
meaning the valid configuration information which can be displayed with the display
To Next Page
Loading...
Need help?
General
