H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-1
Chapter 5 BGP Configuration Commands
 Note:
The term “router” in this document refers to a generic router or an Ethernet switch
running routing protocols.
5.1 BGP Configuration Commands
 Note:
For routing policy configuration commands, refer to Routing Policy Commands .
5.1.1 aggregate
Syntax
aggregate ip-address { mask | mask-length } [ as-set | attribute-policy
route-policy-name | detail-suppressed | origin-policy route-policy-name |
suppress-policy route-policy-name ] *
undo aggregate ip-address { mask | mask-length }
View
BGP view
Parameters
ip-address: Summary address.
mask: Summary mask, in dotted decimal notation.
mask-length: Summary mask length, in the range 0 to 32.
as-set: Creates a summary with AS set.
attribute-policy route-policy-name: Sets the attributes of the summary route according
to the routing policy, the name of which is a string of 1 to 19 characters.
detail-suppressed: Only advertises the summary route.