Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-23
11.110.0.40 Vlan2 00:33:20 00:01:25 1
11.110.0.20 Vlan3 00:04:53 00:01:22 1
# View the detailed information of the PIM neighbor whose IP address is 11.110.0.20.
<Sysname> display pim neighbor 11.110.0.20 verbose
Neighbor: 11.110.0.20
Interface: Vlan-interface3
Uptime: 00:00:10
Expiry time: 00:00:30
DR Priority: 1
Generation ID: 0X2ACEFE15
Holdtime: 105 s
LAN delay: 500 ms
Override interval: 2500 ms
State refresh interval: 60 ms
Neighbor tracking: Disabled
4.1.22 display pim routing-table
Syntax
display pim routing-table [ group-address [ mask { mask-length | mask } ] |
source-address [ mask { mask-length | mask } ] | incoming-interface [ interface-type
interface-number | register ] | outgoing-interface { include | exclude | match }
{ interface-type interface-number | register } | mode mode-type | flags flag-value | fsm ]
*
View
Any view
Parameters
group-address: Multicast group address, in the range of 224.0.0.0 to 239.255.255.255.
source-address: Multicast source address.
mask: Mask of the multicast group/source address, 255.255.255.255 by default.
mask-length: Mask length of the multicast group/source address, in the range of 0 to 32.
The system default is 32.
incoming-interface: Displays routing entries that contain the specified interface as the
incoming interface.
interface-type interface-number: Specifies an interface by its type and number.
register: Specifies the register interface. This keyword is valid only if mode-type is not
specified or is sm.
To Next Page
Loading...
Need help?
General
