H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-31
Table 3-16 Description on the fields of the display ospf vlink command
Field Description
Virtual-link Neighbor-id
ID of the neighbor connected to the router via the virtual
link
Neighbor-State
Neighbor State: Down, Attempt, Init, 2-Way, ExStart,
Exchange, Loading, Full.
Interface Local interface’s IP address and name of the virtual link
Cost Interface route cost
State Interface state
Type Type: virtual link
Transit Area Transit area ID
Timers
Values of timers: hello, dead, poll (NBMA), retransmit,
and interface transmission delay
3.1.24 enable log
Syntax
enable log [ config | error | state ]
undo enable log [ config | error | state ]
View
OSPF view
Parameters
config: Enables configuration logging.
error: Enables error logging.
state: Enables state logging.
Description
Use the enable command to enable specified OSPF logging.
Use the undo enable command to disable specified OSPF logging.
OSPF logging is disabled by default.
If no keyword is specified, all logging is enabled.
Examples
# Enable OSPF logging.
<Sysname> system-view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English