Command Manual – IP Addressing and Performance
H3C S7500E Series Ethernet Switches
Chapter 2 IP Performance Configuration
Commands
2-6
Table 2-3 Description on the fields of the display icmp statistics command
Field Description
bad formats Number of input wrong format packets
bad checksum Number of input wrong checksum packets
echo Number of input/output echo packets
destination unreachable Number of input/output destination unreachable packets
source quench Number of input/output source quench packets
redirects Number of input/output redirection packets
echo reply Number of input/output replies
parameter problem Number of input/output parameter problem packets
timestamp Number of input/output time stamp packets
information request Number of input information request packets
mask requests Number of input/output mask requests
mask replies Number of input/output mask replies
information reply Number of output information reply packets
time exceeded Number of input/output expiration packets
2.1.5 display ip socket
Syntax
display ip socket [ socktype sock-type ] [ task-id socket-id ] [ slot slot-number ]
View
Any view
Parameters
socktype sock-type: Displays the socket information of this type. The sock type is in
the range 1 to 3, corresponding to TCP, UDP and raw IP respectively.
task-id: Displays the socket information of this task. Task ID is in the range 1 to 100.
socket-id: Displays the information of the socket. Socket ID is in the range 0 to 3072.
slot-number: Displays the socket information of the slot.
Description
Use the display ip socket command to display socket information.
To Next Page
Loading...
Need help?
General
