H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GARP/GVRP Configuration Commands
4-5
4.1.5 reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameters
interface interface-list: Specifies an Ethernet port list, in the format of { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
means that you can specify up to 10 port ranges. A port range defined without the to
interface-type interface-number portion comprises only one port.
Description
Use the reset garp statistics command to clear GARP statistics of specific or all the
ports.
Note that:
z If the interface interface-list keyword-argument combination is not specified, this
command clears the GARP statistics of all the ports.
z If the interface interface-list keyword-argument combination is specified, this
command clears the GARP statistics of the specified ports.
Related commands: display gvrp statistics.
Examples
# Clear statistics about GARP on all ports.
<Sysname> reset garp statistics
4.2 GVRP Configuration Commands
4.2.1 display gvrp local-vlan interface
Syntax
display gvrp local-vlan interface interface-type interface-number
View
Any view
Parameters
interface-type interface-number: Specifies an interface by its type and number.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English