H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GARP/GVRP Configuration Commands
4-2
4.1.2 display garp timer
Syntax
display garp timer [ interface interface-list ]
View
Any view
Parameters
interface interface-list: Specifies an Ethernet port list, in the format of { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
means that you can specify up to 10 port ranges. A port range defined without the to
interface-type interface-number portion comprises only one port.
Description
Use the display garp timer command to display GARP timer settings of specific ports.
Note that:
z If the interface interface-list keyword-argument combination is not specified, this
command displays the GARP timer settings of all the ports.
z If the interface interface-list keyword-argument combination is specified, this
command displays the GARP timer settings of the specified ports.
Related commands: garp timer, garp timer leaveall.
Examples
# Display GARP timers on port Ethernet 2/0/1.
<Sysname> display garp timer interface ethernet 2/0/1
GARP timers on port Ethernet2/0/1
Garp Join Time : 20 centiseconds
Garp Leave Time : 60 centiseconds
Garp LeaveAll Time : 1000 centiseconds
Garp Hold Time : 10 centiseconds
4.1.3 garp timer
Syntax
garp timer { hold | join | leave } timer-value
undo garp timer { hold | join | leave }
View
Ethernet port view, port group view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English