Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-44
Examples
# Enable the listening port of the RADIUS client.
<Sysname> system-view
[Sysname] radius client enable
1.2.10 radius nas-ip
Syntax
radius nas-ip ip-address
undo radius nas-ip
View
System view
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device
and cannot be all 0s address, all 1s address, a class D address, a class E address or a
loopback address.
Description
Use the radius nas-ip command to set the IP address for the device to use as the
source address of the RADIUS packets to be sent to the server.
Use the undo radius nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the
outbound port.
Note that:
z Specifying a source address for the RADIUS packets to be sent to the server can
avoid the situation where the packets sent back by the RADIUS server cannot
reach the device as the result of a physical interface failure.
z If you configure the command for more than one time, the last configuration takes
effect.
z The nas-ip command in RADIUS scheme view is only for the current RADIUS
scheme, while the radius nas-ip command in system view is for all RADIUS
schemes. However, the nas-ip command in RADIUS scheme view overwrites the
configuration of the radius nas-ip command.
Related commands: nas-ip.
Examples
# Set the IP address for the device to use as the source address of the RADIUS
packets to 129.10.10.1.
To Next Page
Loading...
Need help?
General
