H3C S7500E Series

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-32
3.1.27 ospfv3 mtu-ignore
Syntax
ospfv3 mtu-ignore [ instance instance-id ]
undo ospfv3 mtu-ignore [ instance instance-id ]
View
Interface view
Parameters
instance-id: Instance ID, in the range 0 to 255, which defaults to 0.
Description
Use the ospfv3 mtu-ignore command to configure an interface to ignore MTU when
sending DD packets.
Use the undo ospfv3 mtu-ignore command to restore the default configuration.
MTU is not ignored by default.
Examples
# Configure VLAN-interface 10 that belongs to instance 1 to ignore MTU.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 mtu-ignore instance 1
3.1.28 ospfv3 timer dead
Syntax
ospfv3 timer dead seconds [ instance instance-id ]
undo ospfv3 timer dead [ instance instance-id ]
View
Interface view
Parameters
seconds: Dead time in seconds, ranging from 1 to 65535.
instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.
Description
Use the ospfv3 timer dead command to configure the OSPFv3 neighbor dead time for
an interface that belongs to a specified instance.