H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-39
undo peer { group-name | ip-address } as-path-acl as-path-acl-number { export |
import }
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
as-path-acl-number: AS path ACL number, in the range 1 to 256.
export: Filters outgoing routes.
import: Filters incoming routes.
Description
Use the peer as-path-acl command to configure the filtering of routes incoming from or
outgoing to a peer/peer group based on a specified AS path ACL.
Use the undo peer as-path-acl command to remove the configuration.
By default, no AS path ACL filtering is configured.
Related commands: ip as-path-acl, if-match as-path, apply as-path.
Examples
# In BGP view, reference the AS path ACL 1 to filter routes outgoing to the peer group
test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test as-path-acl 1 export
5.1.44 peer capability-advertise conventional
Syntax
peer { group-name | ip-address } capability-advertise conventional
undo peer { group-name | ip-address } capability-advertise conventional
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.