H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-20
4.1.16 display isis statistics
Syntax
display isis statistics [ level-1 | level-2 | level-1-2 ]
View
Any view
Parameters
level-1: IS-IS Level-1 statistic information.
level-2: IS-IS Level-2 statistic information.
level-1-2: IS-IS Level-1-2 statistic information.
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
Description
Use the display isis statistics command to display the statistic information of IS-IS
process, including the number of routes learned from other IS-IS routers, the number of
routes redistributed from other protocols and the number of LSP generated locally.
Examples
# Display IS-IS statistics.
<Sysname> display isis statistics
Statistics information for ISIS(1)
----------------------------------
Level-1 Statistics
------------------
Learnt routes information:
Total IPv4 Learnt Destinations: 4
Total IPv6 Learnt Destinations: 0
Imported routes information:
IPv4 Imported Routes:
Static: 0 Direct: 0
ISIS: 0 BGP: 0
RIP: 0 OSPF: 0
IPv6 Imported Routes:
Static: 0 Direct: 0
ISISv6: 0 BGP4+: 0