H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-18
nssa-external-type1or2: OSPF NSSA Type 1 or 2 external routes.
Description
Use the if-match route-type command to configure a route type match criterion.
Use the undo if-match route-type command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Create a routing policy named policy1 with node 10, matching mode as permit. Define
an if-match clause to match internal routes.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match route-type internal
6.1.23 if-match tag
Syntax
if-match tag value
undo if-match tag
View
Routing policy view
Parameters
value: Specifies a tag value, ranging from 0 to 4294967295.
Description
Use the if-match tag command to match routing information having the specified tag.
Use the undo if-match tag command to remove the match criterion.
The match criterion is not configured by default.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, route-policy, apply ip-address next-hop, apply cost,
apply local-preference, apply origin, apply tag.
Examples
# Create a routing policy named policy1 with node 10, matching mode as permit. Define
an if-match clause to permit RIP, OSPF and IS-IS routing information with the tag as 8.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match tag 8