H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-23
Parameters
protocol: Displays routes of a routing protocol, which can be bgp4+, direct, isisv6,
ospfv3, ripng and static.
inactive: Displays only inactive routes. Without the keyword, all active and inactive
routes are displayed.
verbose: Displays both active and inactive verbose routing information. Without this
keyword, only brief active routing information is displayed.
Description
Use the display ipv6 routing-table protocol command to display routes of a specified
routing protocol.
Examples
# Display brief information about all direct routes.
<Sysname> display ipv6 routing-table protocol direct
Direct Routing Table :
Summary Count : 1
Direct Routing Table's Status : < Active >
Summary Count : 1
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Direct Routing Table's Status : < Inactive >
Summary Count : 0
Refer to Table 1-9 for description about the above output.
1.1.17 display ipv6 routing-table statistics
Syntax
display ipv6 routing-table statistics
View
Any view
Parameters
None