Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-3
Field Description
ge greater-equal, the lower limit prefix length
Le less-equal, the upper limit prefix length
6.2.3 if-match ipv6
Syntax
if-match ipv6 { address | next-hop | route-source } { acl acl6-number | prefix-list
ipv6-prefix-name }
undo if-match ipv6 { address | next-hop | route-source } [ acl | prefix-list ]
View
Routing policy view
Parameters
address: Matches the destination address of IPv6 routing information.
next-hop: Matches the next hop of IPv6 routing information.
route-source: Matches the source address of IPv6 routing information.
acl acl6-number: Specifies the number of an IPv6 ACL for filtering, in the range 2000 to
3999 for address, and 2000 to 2999 for next-hop and route-source.
prefix-list ipv6-prefix-name: Specifies the name of a IPv6 prefix list for filtering, a string
of 1 to 19 characters.
Description
Use the if-match ipv6 command to configure a destination, next hop or source address
based match criterion for IPv6 routes.
Use the undo if-match ipv6 command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Create a routing policy named policy1 with node 10, matching mode as permit. Define
an if-match clause to permit the routing information whose next hop address matches
IPv6 prefix list p1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ipv6 next-hop prefix-list p1
To Next Page
Loading...
Need help?
General
