H3C S7500E Series Command Manual

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-5
Field Description
Protocol-link
Port protocol link state, which can be up or
down
Protocol type Port protocol type
Main IP Main IP
The brief information of interface(s)
under bridge mode
Brief information of port(s) in bridge mode
Speed Port rate, in bps
Duplex
Duplex mode, which can be half (half duplex),
full (full duplex), or auto (auto-negotiation).
PVID Default VLAN ID
Table 1-2 Acronyms for different types of ports
Port name Acronyms
Ethernet Eth
GigabitEthernet GE
Ten-GigabitEthernet XGE
1.1.4 display interface
Syntax
display interface [ interface-type [ interface-number ] ]
View
Any view
Parameters
interface-type: Type of a specified port.
interface-number: Number of a specified port.
Description
Use the display interface command to display the current state of a specified port and
related information.
z If neither port type nor port number is specified, all port information will be
displayed;
z If only port type is specified, then only information of this particular type of port will
be displayed.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English