H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-16
Field Description
Inter Area Inter-area route number
ASE ASE route number
3.1.14 display ospf error
Syntax
display ospf [ process-id ] error
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf error command to display OSPF error information.
If no process is specified, the OSPF error information of all OSPF processes is
displayed.
Examples
# Display OSPF error information.
<Sysname> display ospf error
OSPF Process 1 with Router ID 192.168.80.100
OSPF Packet Error Statistics
0 : OSPF Router ID confusion 0 : OSPF bad packet
0 : OSPF bad version 0 : OSPF bad checksum
0 : OSPF bad area ID 0 : OSPF drop on unnumber interface
0 : OSPF bad virtual link 0 : OSPF bad authentication type
0 : OSPF bad authentication key 0 : OSPF packet too small
0 : OSPF Neighbor state low 0 : OSPF transmit error
0 : OSPF interface down 0 : OSPF unknown neighbor
0 : HELLO: Netmask mismatch 0 : HELLO: Hello timer mismatch
0 : HELLO: Dead timer mismatch 0 : HELLO: Extern option mismatch
0 : HELLO: NBMA neighbor unknown 0 : DD: MTU option mismatch
0 : DD: Unknown LSA type 0 : DD: Extern option mismatch
0 : LS ACK: Bad ack 0 : LS ACK: Unknown LSA type
0 : LS REQ: Empty request 0 : LS REQ: Bad request