H3C S7500E Series

Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-20
undo slave auto-update config
View
System view
Parameters
None
Description
Use the slave auto-update config command to enable auto-update between the AMB
and SMB (standby main board).
Use the undo slave auto-update config command to disable auto-update between
the AMB and SMB.
By default, auto-update between the AMB and SMB is enabled.
Examples
# Enable the auto-update between the AMB and SMB.
<Sysname> system-view
[Sysname] slave auto-update config
1.2.8 startup saved-configuration
Syntax
startup saved-configuration cfgfile
undo startup saved-configuration
View
User view
Parameters
cfgfile: Configuration file name.
Description
Use the startup saved-configuration command to specify a configuration file for next
startup.
Use the undo startup saved-configuration command to start up with an empty
configuration, which means startup with the initial configuration of the system.
The specified file must be ended with a .cfg extension and saved in the root directory of
the storage device.
Related commands: display startup.