H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-14
Field Description
Scope Scope of the BSR
Uptime
Length of time for which this BSR has been up,
in hours:minutes:seconds
Next BSR message scheduled
at
Length of time in which the BSR will expire, in
hours:minutes:seconds
Candidate RP Address of the C-RP
Priority Priority of the C-RP
HoldTime Timeout time of the C-RP
Advertisement Interval
Interval at which the C-RP sends advertisement
messages
Next advertisement scheduled at
Length of time in which the C-RP will send the
next advertisement message, in
hours:minutes:seconds
4.1.16 display pim claimed-route
Syntax
display pim claimed-route [ source-address ]
View
Any view
Parameters
source-address: Displays the information of the unicast route to a particular multicast
source. If you do not provide this argument, this command will display the information
about all unicast routes used by PIM.
Description
Use the display pim claimed-route command to view the information of unicast
routes used by PIM.
If an (S, G) is marked SPT, this (S, G) entry uses a unicast route.
Examples
# View the information of all unicast routes used by PIM.
<Sysname> display pim claimed-route
RPF information about: 172.168.0.0
RPF interface: Vlan-interface2, RPF neighbor: 172.168.0.2
Referenced route/mask: 172.168.0.0/24

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English