To Next Page

To Previous Page

Command Manual – VLAN

H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands

1-10

Examples

# Add Ethernet 2/0/1 to VLAN 3.

<Sysname> system-view

[Sysname] vlan 3

[Sysname-vlan3] quit

[Sysname] interface ethernet 2/0/1

[Sysname-Ethernet2/0/1] port access vlan 3

1.2.3 port hybrid pvid vlan

Syntax

port hybrid pvid vlan vlan-id

undo port hybrid pvid

View

Ethernet port view, port group view

Parameters

vlan-id : VLAN ID, in the range 1 to 4094.

Description

Use the port hybrid pvid vlan command to configure the default VLAN ID of the

Hybrid port.

Use the undo port hybrid pvid command to restore the default, VLAN 1.

Execution of the undo vlan command on a Hybrid port to remove the default VLAN

does not affect the default VLAN configuration. That is to say, the non-existent VLAN

can still be the default VLAN.

Execution of the above commands under Ethernet port view will apply to the current

port only whereas under port group view will apply to all ports in the port group view.

The default VLAN ID of local Hybrid port must be consistent with that of the peer;

otherwise, packets cannot be forwarded properly.

Related commands: port link-type.

Examples

# Configure the default VLAN ID for the Hybrid port Ethernet 2/0/1 to be 100.

<Sysname> system-view

[Sysname] vlan 100

[Sysname-vlan100] quit

[Sysname] interface ethernet 2/0/1

[Sysname-Ethernet2/0/1] port link-type hybrid

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series