H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-8
1.1.6 vrrp ping-enable
Syntax
vrrp ping-enable
undo vrrp ping-enable
View
System view
Parameters
None
Description
Use the vrrp ping-enable command to enable users to ping the virtual IP addresses of
standby groups.
Use the undo vrrp ping-enable command to disable the virtual IP addresses of
standby groups from being pinged.
By default, the virtual IP addresses of standby groups can be pinged.
Perform this configuration before configuring a standby group.
Examples
# Enable users to ping the virtual IP addresses of standby groups.
<Sysname> system-view
[Sysname] vrrp ping-enable
1.1.7 vrrp un-check ttl
Syntax
vrrp un-check ttl
undo vrrp un-check ttl
View
Interface view
Parameters
None
Description
Use the vrrp un-check ttl command to disable TTL check on VRRP packets.
Use the undo vrrp un-check ttl command to enable TTL check on VRRP packets.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English