H3C S7500E Series

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-20
Field Description
Output AC Current A/B/C Alarm
Output three-phase AC current state. See
Table
1-8.
Volt Phrase AB/BC/CA Alarm AC voltage input state. See Table 1-8.
1.1.14 display poe-power supervision-module
Syntax
display poe-power supervision-module
View
Any view
Parameters
None
Description
Use the display poe-power supervision-module command to display the information
of the monitoring module of the PoE power.
Examples
# Display the information of the monitoring module of the PoE power.
<Sysname> display poe-power supervision-module
Supervision Version : 2.6
Supervision Name : Summer Pms
PoE Power Type : PSE2500-A
PoE Current Power : 600 W
PoE Average Power : 630 W
PoE Peak Power : 650 W
PoE Nominal Power : 2400 W
PSU Available Number : 1
PSU 1:
Nominal Output Power : 2500(W)(220V)/1250(W)(110V)
Hardware Version Info : NP Series
Table 1-13 Description on the fields of display poe-power supervision-module
Field Description
Supervision Version
Software version number of the monitoring module of
the PoE power
Supervision Name Name of the monitoring module of the PoE power