Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-14
View
User view
Parameters
dest-addr: IP address or name of a TFTP server. The address cannot be an IPv6
address.
dest-filename: Target filename used to save the next startup configuration file on the
server.
Description
Use the backup startup-configuration command to backup the startup configuration
file (for next startup) using a filename you specify. If you do not specify this filename,
the original filename is used.
z This command only backs up the configuration file of the main board for next
startup.
z This command backs up the configuration file for next startup.
Presently, the device uses TFTP to backup configuration files.
Examples
# Backup the configuration file for next startup on the TFTP server with IP address
2.2..2.2, using the filename config.cfg.
<Sysname> backup startup-configuration to 2.2.2.2 config.cfg
Backup next startup-configuration file to 2.2.2.2, please wait…
finished!
<Sysname>
1.2.2 display saved-configuration
Syntax
display saved-configuration [ by-linenum ]
View
Any view
Parameters
by-linenum: Identifies each line of displayed information with a line number.
Description
Use the display saved-configuration command to display the initial configuration file
saved in the storage device.
To Next Page
Loading...
Need help?
General
